Product Description

ABOUT BORE-TIPS®

• Bore-tips® are available in 3 rifle  caliber sizes – .22/5.56mm, .243/6mm & .30/7.62mm.
• Easier, faster and simpler than traditional patches and jags.
• Replaces patches and jags in traditional firearms cleaning.
• Provides superior barrel cleaning.
• Provides 360 degree bore coverage.
• Provides uniform application of oil for storage.
• Lint free Bore-tips® are plastic foam over a plastic core.
• Economical, washable and reusable.
• Stands up to most commercially available solvents.
• Color coded for easy caliber identification.
• Threaded to fit on standard 8/32 cleaning rods.
• Made in the USA.

ABOUT GUN-TIPS™

• Gun-tips™ foam swabs are reusable and replace cotton swabs.
• Fiber free, does not shed or leave lint behind.
• Perfect for cleaning and lubricating hard to reach places.
• Available in a variety of shapes, sizes and packages.
• Economical, washable and reusable, just like Bore-tips®.
• Made in the USA.

HOW TO USE BORE-TIPS®

Use a Bore-tip to apply the solvent to the barrel. Then, after allowing the solvent time to work, brush the bore to break up any fouling. Next, use a clean Bore-tip to push the fouling out the bore. When the now dirty Boretip clears the bore, wet it with a little solvent and then squeeze it with an absorbent rag or paper towel, this will blot the dirt off. After blotting, the Bore-tip should be clean enough to continue using to remove the fouling until you are finished cleaning. When you are satisfied with the cleanliness of your barrel, use a clean Bore-tip to dry the bore. If you wish to lubricate, you can use another Bore-tip to apply lubricant. PLEASE NOTE: Always make sure the firearm is unloaded before cleaning. If you lubricate the barrel it must be dry swabbed before it is fired again. The bore should ALWAYS be clear and dry before firing.

HOW TO CLEAN BORE-TIPS®

For faster cleaning use mineral spirits. Apply mineral spirits to the Bore-tip and squeeze/blot into an absorbent rag or paper towel. When the Bore-tip is clean, let dry and reuse. Using soap and water, squeeze to blot out any excess solvent or dirt. Next, wash the Bore-tip with a grease cutting soap and warm water. Once clean, rinse then let dry completely.

Additional Information